Tying method of hook and line

Tying method is as follows:

Tying method 1

Tying method 2

Tying method 3

Problems that should be noted when tying hooks:

1. Tied hooks, brain line must be in the center of the front of the hook shank (i.e., hook shank towards the hook tip side) close to the hook shank, only by doing so, the brain line will be able to be longitudinally loaded at the same time with the hook after hooking the fish and won't run away because of the brain line injury. In addition, in the case of double hook fishing, only this will make the single hook to the axis of the brain line to minimize the radius of rotation, double brain line is not easy to entangle.

2. The number of coils wrapped around the hook handle depends on the fish conditions, but it is recommended that no less than 5 to 8 turns. Too much will increase the burden on the hook and waste the thread; too little will make it hard to tie, and it will be easy to turn or unhook the hook.

3, the coil should be wound in an orderly manner, tightening the line should be tight without hurting the brain line as a principle, do not strangle the brain line at the shank of the hook, affecting the strength of the line.

4, left in the hook body of the thread should not be too long, too long will affect the fish will be hooked into the mouth, the best use of thread attached to the inside of the hook shank hook tying method.

5, tied coil should be as close as possible to the end of the hook shank, to avoid the hook shank hurt line when fishing due to the line sliding and change the direction of the hook force.

6. It is recommended that you dip the line in water when you tighten it, so that it is tight and does not hurt the line.