What should I do if the faucet switch of Aidiwei commercial electric water heater leaks?

Solution to water leakage of faucet switch of water heater;

1. If the hot and cold taps are controlled by the main water inlet valve, close the main valve. When the cold and hot water inlet pipes are separated, close the corresponding two valves.

2. Open the attachment "0 1 cold and hot standard (handle fixing screw hole plug)" with flat head screws, as shown in the above figure;

3. Insert the flat head screw into the hole plug (cold and hot standard hole) of the handle fixing screw, and turn the screw counterclockwise (left-handed) for about 3 turns;

4. Grasp the faucet handle with your left hand, push it upward, and tap it upward with the handle at the rear end of the screw (it must be non-metallic, otherwise it will damage the outer surface of the faucet) to separate the accessory "02 outlet handle";

5. Assemble "03 end cover" counterclockwise (left-handed), and the end cover is separated from the main body;

6. Place the starting end of adjustable wrench at the hexagonal position of the pipe fitting "04-core tightening hexagonal sleeve", adjust the size of the starting end of adjustable wrench, rotate it counterclockwise, remove the ceramic valve core for inspection, if it is intact, rotate it clockwise (right hand), and tighten it to stop working; If it is damaged, replace it with a new valve core.