How to embroider cross-stitch insoles

There are three kinds of cross-stitch insoles, namely pinhole cross-stitch insoles, traditional cross-stitch cloth insoles and plastic insoles. I don't know which one you are talking about. The embroidery method of pinhole cross-stitch insole is basically the same as that of traditional cross-stitch insole, which can be divided into the following steps:

1, which passes through the lower left hole of the lattice to be embroidered;

2. Insert the needle into the inclined hole and at the same time insert the needle out of the hole on the left side in the horizontal direction;

3. In the same way as in 2, simultaneously insert the needle into the oblique hole and out of the horizontal hole;

4. Repeat the process of 1 and 2, and embroider into a cross shape from top to bottom. In the state of 3, put it into the hole in the lower right corner of the diagonal direction, and then go out from the hole on the left side of the horizontal direction;

5. Thread the line into the hole in the lower right corner diagonally again, and then through the hole in the left direction;

6. If you go back to the starting point, you can complete all the cross figures;

7. The lines on the back will be arranged parallel to each other. Don't tie a knot. Just thread the thread through three or four parallel lines.

8. Cut off the extra thread and tie a knot like this. No matter how you wash it, the thread will not come loose!

Traditional cross-stitch insoles are embroidered according to the embroidery method of cross-stitch, but the cross-stitch cloth itself is not durable and easy to stink. Pinhole cross-stitch insole is punched on the basis of traditional cotton brush, which will not stink feet. There is a rose insole factory in Jinan, and the plastic one is even worse, but it is ugly and smelly.