Wooden bench making method

Wooden bench making method is as follows:

Preparation of materials and tools: pens, sawing, handsaw, drill.

1, the first design sketch, sawing, drilling, installation. Root saw design of the bench drawing, first should be in the prepared boards according to the size of the scribe line, and then start the material.

2, the production of bench surface bench feet slope for 5:1 two-way diagonal mortise and tenon, bench surface and feet of the mortise and tenon production is somewhat difficult, the bench surface of the eye chiseling method for the novice to, it is best to be the front and back according to the size of the drawing of the line chisel a model, with the power drill small drill bit to the eye drilling, and then milled once with a large drill, and finally with chisel milling the eye, so as to ensure the accuracy of the.

3, the production of stool feet sawing, the use of hand saws. When sawing wood, the right hand holds the saw hand tightly, the saw tooth tip down, with the left foot will be tightly pressed wood on the work bench, in order to prevent the wood up and down jumping or left and right movement.

4, under the saw, should be slow and then fast, when the wood is about to saw, with the left hand to cut the wood ready to hold steady, to prevent the wood along the wood grain tear or fall and injure the foot. The tenons of the stool foot and cross post are single-shouldered diagonal tenons.

5, assembly stool side and toe should be in the same vertical line or toe out a little better, to the surface of the stool to play the eye, to grasp the tongue and groove two-way slope angle, unskilled and slowly play on it. Through mortise and tenon on both sides of the fight remember to change the angle, installed and then give the stool through the mortise and tenon to play on the wedge.

6, the last sanding can be.