Video tutorial on how to make a pull wire top handle

Pulling the wire connection fittings are generally used wedge-shaped wire clamps and ?U?-type wire clamps. Pulling line production, the stranded wire according to the length of the required calculation to determine the cut on the handle and the lower handle, and wedge-shaped wire clamps on the upper handle ends and the lower handle and the suspension insulator connection end for fixed binding. Wedge-shaped wire clip tongue and wire contact should be close, no sliding phenomenon after force, wire clip belly in the tail line side, the installation should not damage the wire strands, wire bending part should not be obvious loose strands. Installation must pay attention to the exposed part, do not expose the part of the damage, must be careful to complete the required installation of the pulling line, pulling the line has a certain range of requirements, if more than this range will be the failure of the pulling line, so be sure to pay attention to the pulling of the line of the various steps.