How to look at the direction map when reversing at right angles?

Take the right-leaning warehouse as an example to illustrate the point; Keep the vehicle at a distance of about 1 m from the left side of the road to reverse in parallel;

in the first place

When the lower edge of the left rearview mirror coincides with the starting point induction line (generally yellow dotted line), it will be killed to the right. But remember, the yellow line itself has a width, so we should grasp the timing of this coincidence and follow the principle of sooner rather than later.

Second point

Continue to reverse in the dead direction, check the right rearview mirror while controlling the speed, and master the interval between the garage angle and the car body. 30cm is the best place.

If the interval is less than 30cm, you can adjust the direction and turn it for one or half turn. When the corner line reaches the lower edge of the rearview mirror, kill the direction to the right. If the interval is greater than 30cm, you don't need to move the steering wheel, just return to 30cm.

the third point

After the rear end of the car starts to be put into storage, observe the left and right rearview mirrors, and turn back when the car body is parallel to the sideline. After straightening, if you find that the margins on both sides are inconsistent, you can fine-tune the direction and hit which side is wide.

Fourth point

When the lower line of the left rearview mirror coincides with the left exit line, you can stop. These points can be prepared in advance, because they can be adjusted in advance, and it will be more difficult to adjust after the points.

Fifth point

After reversing into the warehouse, start to leave the warehouse, keep the direction back to normal, go straight, and quickly kill the direction to the left when the hood of the vehicle covers the front roadside line. This position may be different because of the individual's height. You can try several times to find the position that suits you best.

The sixth point

Observe the left rearview mirror after leaving the warehouse, stop when the induction line at the starting point of the left warehouse appears at the lower edge of the left rearview mirror, keep the direction in the state of left killing, and then start the left warehouse dumping.

The positions of the left bin and the right bin are the same, which will not be described here. Students may wish to practice a few more times and make some adjustments according to their own differences.