What are the basic steps for installing a light strip?

Insert the pointed end of the accessory "pin" into the strip, and connect the strip with the "pin" to the strip plug. Do a good job of waterproof treatment, and then put the strip into the light slot with a fixed clip can be fixed.

Specific steps are as follows:

1, first of all, we need to measure the length of the strip to be installed, take the whole number of intercepted or purchased.

2, the strip will be straightened out, not tangled into a ball, the accessories "pin" more pointed end into the strip.

3, will be inserted into the "pin" of the strip connected to the strip plug, still pay attention to the positive and negative direction.

4, the end of the lamp should be plugged on the end of the plug to do a good job of waterproofing, you can use high-pressure waterproof adhesive sealing, and then use waterproof electrical tape winding. Then put the lamp into the lamp slot with a fixed clip can be fixed.

Precautions

1, the whole coil is not unpacked or piled up into a ball, do not electrify the light strip, because the coil brings a strong magnetic field, the heat is also large, will cause a fire.

2, according to the installation length when cutting the strip, only in the printed scissors mark cut, otherwise it will cause one of the units do not light.