Installation technology of wooden wallboard

The partition is used to protect the wall, and its construction will affect the firmness of the wall to a certain extent, so it is necessary to complete the whole construction process step by step and carefully. The installation process of wooden partition is divided into the following steps, each step should ensure the quality, so as to make the wall radiant.

Measuring wall surface

Measure the length and width of the wall, and calculate the integer block of the required wallboard according to the size of the wallboard. The extra space should be completed by splicing the wall panels, and the splicing should be distributed at the ends.

Installation of skirting board

Fix the skirting hook on the wall with expansion screws or steel nails. Hook holes are 7.8cm away from the ground, a hook is fixed every 60cm, and then the skirting line with one end processed into a 45 angle is hung on the hook.

Installation of dado

Insert the wallboard into the skirting line from left to right, and the starting block should be slotted from corner to corner. Install expansion screws or steel nails at a distance of 1.5cm from the top of the panel (in the middle of the width of the panel), and pay attention to the fact that the screws cannot expose the surface of the panel. Apply special glue to the groove of the waistline, and insert the concave-convex surface after a few minutes. The corner must be 45 diagonal.

Installation of full-height wallboard

First, saw off the convex groove of the first partition and planed it with a plane. Then, from the corner, install a 4.9cm( 1.5in) steel nail on the convex part of the groove every 60cm, and the joint of the groove wedge does not need to be glued. Each piece should be hammered tightly and corrected with a ruler. The last piece needs to be coated with special glue on the back of the wallboard.

Installing top corner line

The top corner line can be coated with special glue on both sides, glued to the top corner, pulled apart for a few minutes, and then glued tightly.