How to wire and install fountain underwater lights

1. First, install the underwater lamp of the fountain on the bracket of the underwater lamp, then leave a part of the rubber cable, and keep the rubber cable to be pulled out of the water, so that it can be directly removed from the bracket and then pulled out of the water when changing the lamp next time.

2. When wiring, rubber cables need to be laid with plastic pipes and sealed with waterproof glue, and then the rubber cables are led out of the pool and then connected to the distribution box outside.

Extended data:

Characteristics of underwater lamp:

1, material: generally made of stainless steel and glass. At present, there are two main production processes for stainless steel body of underwater lamps: die drawing (generally, lamps are thin and light, with fast production cycle and low cost) and silica sol dewaxing (generally, lamps are heavy and thick, with slow production cycle and relatively high cost); A few high-grade lamps are made of all copper.

2. light source: at present, it is basically LED, which is divided into small light beads with high power such as 0.06W, 1W, 3W, RGB, etc.

3. Power supply: According to national standards, the voltage of 12V and 24V lower than human safe voltage must be strictly controlled;

4, color: cold, warm, neutral white, red, green, yellow, blue, color;

5. Control mode: always on, built-in MCU synchronous internal control, SPI cascade, DMX5 12 parallel external control;

6. Installation method: surface mounted (bracket led underwater lamp), concealed mounted (embedded LED underwater lamp), and perforated waterscape lamp (fountain lamp).

Baidu encyclopedia-underwater lamp