How to use tin pots correctly

When using the machine for the first time, turn on the power switch and the PID meter will light up. First, set the PID to 250℃ and start heating. At the same time, the tin bar moves back and forth evenly on the electric heating tube. After heating on the heating tube, the tin rod is melted into the tin bath, and the height of molten tin is preferably maintained at about 80%-90% of the depth of the tin bath.

Don't put the tin bar directly on the heating tube by mistake, otherwise the heating tube will burn out if it is too hot; When the amount of molten tin has covered the electric heating tube, the tin bar can be directly put into the tin bath for automatic tin plating (it is suggested that the temperature of the tin bar containing 63% tin should be set at 220℃-250℃ and the temperature of the tin bar containing 60% tin should be set at 250℃-280℃).

Extended data

Pay attention to use

(1) After the solder pot is heated, tin plating or welding can only be carried out after the internal solder is completely melted.

(2) Unplug the power cord when the soldering pot is not used temporarily to avoid fire.

(3) The solder pot should be kept until the solder in it cools down, so as to avoid scalding.

(4) When using the solder pot, it is necessary to prevent the power cord from touching the surface of the solder pot, otherwise it will damage the insulation layer of the power cord, expose the metal wire and cause an electric shock accident.