Brief introduction of operation procedures for tail-watching operation of belt conveyor

Whether the belt conveyor can run normally for a long time is directly related to its correct operation and later maintenance. The main reason for the equipment accident is that the material breaks the conveyor belt and escapes from the torn conveyor belt.

1, the blanking height should be reduced as much as possible to reduce the impact of materials. When the feeding height exceeds 1.2m, the materials should not directly impact the conveyor belt when designing the chute and hopper. When the transported materials are mixed with large pieces, small pieces and powdery materials should first fall on the conveyor belt through a special inclined grating before the materials reach the conveyor belt, and the large pieces will flow onto the small pieces, thus preventing the large pieces from directly impacting the conveyor belt.

2. The factors causing the deviation of the conveyor belt must be eliminated in time, and adjusted according to the adjustment method mentioned in the previous section, so that it does not deviate.

3. As far as possible, the belt conveyor should stop after unloading the belt material, and it is advisable to start with no load. When multiple units form a transportation system together, the opening and closing electrical control system should be compiled according to this requirement.

See: /pt /pt/one/45.html for the specific operation process.