Running through Gigabit Broadband with Cat Stick instead of Light Cat

Use pon stick instead of optical cat to run gigabit (1200Mb) home broadband.

Note that the following adapter is useful, even if you don't need a baffle, you should plug it in, otherwise it won't open.

Note that the telecom home optical fiber is SC UPC interface, and it is suggested to switch to SC/APC interface with jumper, but switching is possible, but there may be problems.

Plug the cat stick into the network card or switch router. This step is to set the registration parameters of the cat stick. It doesn't matter if the negotiation is not good. If it is safe, manually change the rate to 1Gb first. I plug in the network card here, and then the network card is plugged into the computer. The computer sets the address of this network card to any IP of 192 438+068.438+0.0 network segment. Visit the IP page of Cat Bar at192.168.1.10. It takes time for the cat stick to be electrified. ) If you can't access it, please try again later.

Visit192.168.1.10. The default address of my cat stick is this. Ask the seller for your account password and address.

After logging in, fill in the corresponding light cat configuration in the menu -GPON-ONUconfig. I just need to write the logical ID, which is the second line, check the compatibility mode and save it, and then restart the device in the system menu. You don't need to fill in the rest. If you have special needs, you can write them as follows.

After restarting, continue to log in to the web console and check the status. State 5 shown here is normal. Pay attention to the attenuation of light emission and reception. My neighborhood is also normal. This is the same attenuation before the light cat.

Add a VLAN-based dial-up in mixed-mode ADSL to the network interface: VLAN id is 4 1, which may be different for each operator and region, subject to the configuration in Optical Cat. Then save ok.

3.6.0 The new kernel version test solicitation post has been updated to 20220 107-iKuai love fast flow control routing official forum-powered by Discuz!

12-29-23 open wrt-x86-64-generic-squashfs-combined-EFI . img . gz-Share

Here is a deep pit, and some switches are playing with mice like dogs:

He will drop or not forward ipv6 packets because he doesn't know them. At first, my mobile phone always had an ipv6 computer, but I couldn't get it anyway. I didn't expect it to be a switch problem after all night.

1000 or more, if the router is located, it is also a high-end product. Measured CPU usage is less than 40% when running above1.2gb..

uninterrupted

Booty-wearing

This is a note, recording the tossing process for your future reference.

Replace the light cat with a pon stick and run the full gigabit bandwidth-study hard and make progress every day ~

liu.liuy@qq.com

aha

Welcome to the pon module website | ["www.ponstick.com"]