How to make your own bff bracelet

The tutorial is as follows:

1, prepare two 30 cm rope, one end of the rope with a lighter to burn the rope head and then twisted into a point with your fingers, the purpose is to be easy to put smaller beads through. As shown in the picture below put the beads through and leave a proper distance.

String 6

String 5

2. Wind the string as shown below and pull the ends of the string tight.

String 9

String 7

3. The effect after pulling it tight.

String 5

4. Wrap the string as shown.

5. Then this winding, and then pull the ends of the rope tight, do not pull too tight, otherwise the final bracelet back and forth to take wear when more laborious. Boys' hands are stronger, girls will not have this phenomenon.

String 3

String 7

6. Wrap the left side of the string around and tighten it.

String 3

String 4

String 9

7. Wrap the right string as shown.

String 5

8. Wrap it again, then pull the two string ends to either side. String 1

String 9

String 5

9. Repeat this with the left string again.

String 4

String 1

10. Repeat this with the right string.

String 5

8. Wrap again, then pull the two rope ends to either side. String 1

String 9

String 5

9. Repeat this again with the left string.

String 4

10. Repeat this with the right string.

11. Go back and forth a few times and you have this. Be sure to memorize the order, left-right-left-right, otherwise the braided look will not be beautiful. String 1

Generally speaking, the knots are more than 1 centimeter long, too long or too short to look good. String 4

12. Use scissors to cut off the excess rope ends, taking care to leave a slight 3-5 millimeters. String 6

String 9

13. See why you left a few millimeters out? Careful: don't burn it when you fire it

14. The effect of the rope head treatment.