How to make a vase with small mineral water bottles

Life we often run out of things will be the same as hand, in fact, many things can be waste utilization. For example, drinking mineral water bottles. Mineral water bottles can be tied a few small holes in the cap head can be watered flowers, so if the mineral water bottles want to do vases creative? I share several ways to utilize the waste of mineral water bottles. Simple and good-looking Oh ----

With mineral water bottles how to do creative vases

The first: mineral water bottles homemade beautiful vases

When you see this vase work in the picture above will be his beautiful and marveled at it, you are not very much want to have such a vase on your table? But can you think of how it is made? In fact, it is only with the usual we discarded Coke bottles, mineral water bottles, and then after a very simple transformation and become, is not very want to try, then with 63diy a mineral water bottles diy creative vase production step by step, I believe that after watching you can make such a beautiful vase to

You have to prepare some materials: plastic bottles, scissors.

1, first find a 500ml bottle .

2, cut from the top of the bottle.

3, cut into two, leaving the bottom half.

4, then cut vertically, until the position of the pattern.

5, cut into thin strips of the same width.

6. Cut thin strips all around the week of the bottle.

7, now start braiding the flowers .

8, snap the bottle face down so that the cut strips are all spread out.

9, flatten it out so that the strips don't bounce back even when the bottle is placed squarely on the ground.

11: Tuck the first strip as shown.

12: Tuck the second strip in the same way.

13. Tuck strip 3 again.

14: This is a panoramic view with 3 strips tucked.

15: Tuck all the strips in the same way.

16, The same method is used for finishing.

17, the thin strip all tucked after the completion, very simple it.

18, show a top view of the effect.

19, you can arrange flowers.

The second: mineral water bottles homemade do hot flowers hollow vase

Materials needed: beverage bottles, soldering iron, spray paint, flowers

Steps:

1, the soldering iron electrically heated, towards the bottle hot hole.

2, ironing holes can be arbitrary, in the side of the bottle, making the formation of a kind of lace.

Beverage bottles how to make hot flowers hollow vase

3, with a soldering iron in the body of the bottle to connect the hot holes, the entire upper part of the bottle cut down, so that the production of the vase edges can produce irregular shapes.

4, the body of the vase is made up of irregular hot holes to form a personalized skeleton pattern.

How to make a hot flower skeleton vase from a beverage bottle

5, use spray paint to color the bottle evenly

6, finally fill the vase with water, insert fresh illustrations and green leaves, done!

The third: mineral water bottles homemade kind of fashion vase

Material preparation: plastic bottles, dye, brush, tape.

Simple home crafts Plastic bottles into treasure simple vase detailed steps are as follows:

The tape as shown in the way to stick in the plastic bottle, and then apply the dye, and so the dye is dry, and then tear off the tape, a simple and stylish vase on the production of the completion.

Fourth: Make a vase with twine and glass bottles Handmade hanging vase tying method

Make a hanging vase with twine and glass bottles, a very simple DIY from waste, just tie the glass bottles with twine, come and learn it.

Start tying from the mouth of the glass bottle.

Tie the rope loop around the neck of the glass bottle first.

Then tie twine to the rope loop.

Illustration of how to braid.

The ties are the same for all the bottle parts.

The tying method for the bottom of the bottle.

After tying the bottle, you have to leave a small braid at the bottom of the bottle.

Finally, tie the lanyard at the mouth position of the bottle as well.

Simple and nice looking hanging vase is ready.