Traditional Culture Encyclopedia - Traditional culture - How to make a lantern?

How to make a lantern?

Method 1: Material: cloth, 7 wire, round plastic, wooden stick Production method: 4 wire into a curved shape, in the white wire on the top, the bottom of the head to hold into a small hook, in the two wires were made into a round, one on the top, one on the bottom, wrapped tightly in cloth and then put a round plastic at the bottom. Then cut a wire into four sections, the wind do not then hooked on the top hook, and then tied to the wooden stick. The last step is to put the candles in! It's done! Method 2: Materials: bamboo, cotton thread, glue, wire, gauze, candles, cotton thread, bamboo planer, scissors, etc. Steps: 1, put the bamboo in the steam room heated for half an hour, and then take it out, to the shade to dry, but not overly dry, and can not be placed in the sun under the sun 2, bamboo planer planing to remove the rough surface of the bamboo 3, cut the length of the bamboo strips, depending on the size of the lantern 4, the weaving method: To complete the lantern in a crosswise manner 5, the middle of the lantern, tie a few circles of bamboo on the lantern can also be 6, paste the lantern, first mounted on cotton gauze, and then glued to two layers of single-layer paper used for lanterns. Framing cotton gauze to be the first diluted glue, evenly brushed on the surface of the skeleton, and then cut the gauze lightly attached to the frame, and then use a brush dipped in glue to brush flat, it should be noted that the brush must be a clean glue brush, otherwise, the light will be a mess. At the same time, the framed paper must also be glued without seams before the real framing is complete 7, will be placed in a cool ventilated place to dry the lantern. 8, color painting. Painting according to personal taste to the desired pattern. 9, after painting, according to the actual situation to decide whether to write text. To the text, the pattern is completely dry, and then brush a layer of tung oil, and then wait for the tung oil to dry, the lantern is finished. Here are illustrations: /dispbbs.asp?boardID=26&ID=588&page=4 /viewthread.php?tid=7384