How to open the lid of water dispenser bucket

The method is as follows:

1 First, there is a circle of plastic around the water outlet of bottled water, and a round plastic is attached to the water outlet at the water outlet. This piece of plastic has an arrow.

2. Pull or cut the plastic outside the arrow by hand or scissors.

3, where you can pull it by hand, pull it away by hand. Then you can see that there is still a layer of bottled water that has not been opened.

4, lift the bucket, put the bottled water on the water dispenser, it will be pushed away.

5. If you need to remove the lid of the finished barrel, you can take a round wooden stick with a diameter of about 1cm or the handle of a household pliers and pass it through the middle of the lid for about 2~3cm. Pry it up.

6. If it is a disposable cover, it is a disposable molded cover with a heat sealing film (certificate) attached to the top. This style of cover can't be reused. After drinking water, the lid of the bucket needs to be replaced. Lever it out with a round wooden stick with a diameter of about 1cm.

Extended data:

Tips for cleaning drinking fountains:

1, unplug the power plug and remove the bucket before washing the water dispenser, then open the drain pipe behind the water dispenser to drain the remaining water, and then turn on the hot and cold water switch to drain the water.

2. Remove the "smart seat" (that is, the part where the water dispenser contacts the spring barrel), and carefully scrub the inside and outside of the inner container and cover of the water dispenser with alcohol cotton.

3. Pour a bottle of disinfectant into the water dispenser, then pour some clean water into the cup and let the water soak the plastic rod in the middle.

4. After soaking for about five minutes, brush around with a toothbrush.

5. Turn on all switches of the water dispenser, including the drain pipe and drinking water switch, and discharge the disinfectant.

6. Rinse the whole cavity of the water dispenser with clear water, and do this for several times in a row, then turn on all the switches and drain the rinsing liquid. The water dispenser has been cleaned.

5. If you just want to take off the lid of the water dispenser bucket after drinking, take a round wooden stick with a diameter of about 1cm or the handle of a household pliers, pass through the middle of the lid for about 2~3cm and pry it up.

If the lid is tight, pry it slowly from the small exit in all directions, loosen it and then pull it down.

6. If it is a disposable cover, it is a one-time molded cover with a heat sealing film (certificate) attached to the top. This style of cover can't be reused.

After drinking water, the lid of the bucket needs to be replaced. Use a round stick with a diameter of about 1cm to pry it out at the small mouth of the barrel cover.

Extended data:

Tips for cleaning drinking fountains:

1, unplug the power plug and remove the bucket before washing the water dispenser, then open the drain pipe behind the water dispenser to drain the remaining water, and then turn on the hot and cold water switch to drain the water.

2. Remove the "smart seat" (that is, the part where the water dispenser contacts the spring barrel), and carefully scrub the inside and outside of the inner container and cover of the water dispenser with alcohol cotton.

3. Pour a bottle of disinfectant into the water dispenser, then pour some clean water into the cup and let the water soak the plastic rod in the middle.

4. After soaking for about five minutes, brush around with a toothbrush.

5. Turn on all switches of the water dispenser, including the drain pipe and drinking water switch, and discharge the disinfectant.

6. Rinse the whole cavity of the water dispenser with clear water, and it is enough to wash it several times in a row. Of course, it is better to wash it several times. Finally, turn on all switches to discharge the washing liquid. The water dispenser has been cleaned.