How to tear the tempered film?

Method 1: 0 1 pry up the toughened film in the corner of the mobile phone with sharp tools. Here, the sharp tip of a very sharp knife is used as an example. Everyone should choose according to the tools at hand, and pay attention to the upward strength in the process of prying, so as not to scratch the phone.

If it is a good quality toughened glass protective film for mobile phones, you can tear it off directly by tilting a corner, and there will be no glue.

If it is a protective film of ordinary quality, it is recommended to pry all the toughened films at the four corners of the mobile phone in the same way as above (pry it slightly hard so that all the toughened films at the four sides can be pulled up), then grab the lower corner and pull it up hard, and then the whole toughened film of the mobile phone will start to loosen, and pull all the four corners up until all the toughened films of the mobile phone are removed.

Method 2 0 1 For the toughened film that is difficult to tear off, or the damaged toughened film cannot be torn off by the above method, you can add a little heat to the toughened film with a hair dryer or a hot cloth, and be careful not to raise the temperature too high.

Then slowly cut in from the corner with a blade, and be careful not to scratch the screen, as shown in the figure below.

Tilt up a part of the blade, don't break it, the glass film will break bit by bit.

Then keep the angle between the inclined part and the screen of the mobile phone below 45 degrees, and slowly pull up the glass film.

Then you can take off the tempered film.

Method 3: 0 1 You can also use that kind of wide tape to stick the top of the tempered glass film first, then scratch it with your nails a little bit, and then lift the tape to tear off the whole tempered glass film.