Size, length and dimensions of each section of fishing rod

The longest fishing rod is the handle, with 60 long rods 1 m and short rods 15.

1, and the length of the sea pole is generally 1.6m, 1.8m, 2. 1m, 2.4m, 2.7m, 3.0m, 3.6m, 3.9m, 4.2m, 4.8m and 3.3m. ..

The fishing rod of the sea pole has the functions of extending the fishing point by throwing the line far away, and freely releasing and winding the line according to the winding amount. In fact, according to this function, sea poles can be divided into boat fishing poles, rock fishing poles, beach fishing poles, snapper fishing poles and trout fishing poles.

2. The length of the flow pole is generally 2.7m, 3.6m, 4.5m and 5.4m.. ..

The drift rod is mainly used for fishing small and medium-sized fish such as horse mouth fish, long snout fish, short-bearded jaw fish and oily fish. The characteristics of the fishing rod are that the length of the contracted fishing rod is mostly 58 cm or 37 cm, which is convenient to carry; The front tip of the fishing rod is solid and thin, with good toughness.

3. The length of hand lever is generally 2. 1m, 2.4m, 2.7m, 3.0m, 3.3m, 3.9m, 4.2m, 4.5m, 4.8m, 5.4m, 6.3m ... Ordinary lever length is 3.6m, 4.5m, 5.4m, and non-standard length is 2./kloc-0. ..

The length of the whole fishing rod after shrinkage is about 1 m, so as to reduce the number of knots of the fishing rod and keep the whole fishing rod with good flexibility; The front pole is thin and has good toughness.

4. Rock pillars are generally 4.5m, 4.8m, 5.4m, 6.3m and 7.2m. ..

When the rock rod is used as a hand rod, the fishing line with the same length as the fishing rod or 30-50 cm longer or 30-50cm shorter can be released through the reel, and it can be used according to the operation method of the hand rod. The difference is that when the fisherman catches a big fish, the dual-purpose rod can pay out and take in the line, because the fish has strong freedom, it is not easy to break the rod or break the line. If used as a sea pole, it can be thrown to extend the fishing point.

Extended data:

Fishing operation method:

1, pull it out directly from the top when unloading the sheath, and the tail joint will be broken if you twist and pry it hard.

2. When fishing and pulling the pole, the front and rear conductive rings should be aligned, otherwise the main line will wrap around the pole or the tail tip will be broken.

Don't roll the knotted main line hard to prevent the fishing rod from breaking.

4, as far as possible according to the requirements of the use of pole equipped with pendants, don't let the tail stress is too large.

5. If the bottom hangs when fishing, never lift the pole too hard and dig hard, and most of the consequences will end in broken pole.

6. When fishing in the sand, you should pay attention to prevent sand from entering the rod joint and the fish wheel, and support it with the rod frame or other objects.

7. Fishing should prevent you from getting too excited when you catch a big fish, and work hard with the big fish. There is a pity that the rod is broken and the fish is running away.

8, fishing should be careful to use high voltage power supply equipment, in a thunderstorm, should put down the pole to take lightning protection measures.

9. When fishing on land needs to be transposed, it is necessary to shrink the fishing rod before climbing the mountain, crossing the water and crossing the forest to prevent inconvenience such as broken rod.

10, when you first use it, remember not to swing and stretch, but to pull and stretch, otherwise it will cause "dead joints".

1 1. When fishing on the shore and on the boat, you must take good care of the front and back to prevent injury and damage.

References:

Baidu encyclopedia-fishing rod