How do I set the feed rate in the Feed Rate column of the UG Programming Module in the Feed and Speed column of the UG Programming Module? What do they mean?

1, into the processing module, respectively, set the milling geometry and milling cutter size parameters.

2, open: Cavity milling operation, set: Specify the milling area, as shown in the figure below.

3, milling cutter we have just created a diameter of 8 flat head milling cutter, cutting mode selection pendulum line processing.

4, step selection: tool flat percentage, percentage 50, each cutter male **** depth for constant 0.4mm.

5, cutting parameters set, the pendulum width must be greater than the minimum pendulum width, and is not greater than the step, the use of smooth milling, outward cutting mode, the specific settings settings as shown in the figure.

6, set the feed rate and speed, as shown below.