How to Install Glass Correctly How to Install Glass

1. First clean the dust, oil stain and water film on the surface of glass and aluminum alloy, clean the mortar and foreign matter in the glass notch, dredge the drainage hole, and check whether the sash switch is flexible.

2. When fixing with sealant, adjust the vertical and horizontal position of glass first, and the joint between sealant and glass and its bad mouth must be dry and clean.

3. Then, put the cut glass in place in the aluminum window sash, and the glass in place should stop in the middle of the groove and be completely embedded. After assembly, the gap between the glass and the inlaid groove should be ensured, and shock-absorbing pads should be installed at the main parts to buffer the impact of the opening and closing force.

4. Finally, fix it with adhesive tape: firstly, put rubber battens on both sides of the glass and press them tightly, and check whether the installation position is correct to avoid blocking the drainage hole. Then, take out the rubber battens, evenly brush the rubber (silicone sealants) on the battens, and embed the battens into the glass tank in turn for fixation. The specifications of rubber beads should be consistent with the actual size of the groove, and its length should be shorter than the circumference of the glass. At the corner, cut the strip into eight corners and connect them with glue. Rubber strip should be closely attached to the glass and notch, and shall not be loose. Installation shall not be offset, and rubber strip shall not be forcibly inserted.