Dewatering balance switch for wave washing machine?

The main thing this part is responsible for is the balancing action of the dewatering drum and the top lid opening and closing monitoring. It is located in the position of the lid opening and closing puller of the washing machine, in the vicinity of the timer of dehydration, there is a protruding place in front of the cover of the dewatering and dumping drum, which is about 5-10 cm long. When the lid of the washing machine dumping bucket is closed, the dehydration balance open ring is on, when the dumping bucket is started, it will automatically detect whether the dumping bucket has a serious bias situation. When it is found that there is indeed a severe offset in the drum, the washer's water-holding outer drum will collide with the outstretched lever of the Dewatering Balance Switch, forcing the dewatering drum to stop running.

/

Replacing the spin balance switch is relatively simple. When the washer's spinning lid is closed, the balance switch will be in a sunken state, so make sure the spinning bucket's lid is in an open state when removing the balance switch. Unscrew a few fixing screws around the dehydration balance control switch and replace it with a new one. Note that when you screw in the new screws after replacing them, be sure to tighten the diagonal screws first so that the installation will be more stable.

I don't know if you have noticed, the dumping bucket in the fast running, if you open the cover of the dumping bucket, the dumping bucket will quickly stop rotating. This is also because the moment you open the cover, the balance switch pops up, forcing the drum to slow down and stop. So the dehydration balance switch also plays a certain protective role.