Use of oxygen cylinder flowmeter

The use and installation methods of oxygen cylinder flowmeter are as follows: Before installation, rotate the pressure handle counterclockwise to the lowest position, then connect the pressure gauge (pressure reducer) to the oxygen cylinder and fasten it, open the oxygen cylinder cutting rod for gas transmission, and then rotate the pressure lever of the pressure gauge clockwise to gradually increase the pressure to the required pressure.

Be sure to go to a legal medical oxygen station to replenish oxygen before use. Check the oxygen storage capacity, turn on the gas cylinder switch, and observe the instructions of the oxygen pressure gauge to know the oxygen storage capacity in the oxygen storage cylinder. If the pressure oxygen is less than 0.05-0. 1MPa, medical oxygen should be supplemented.

Matters needing attention in the use of oxygen cylinders

1, the gas in the oxygen cylinder can't be completely used up, and the residual pressure should be maintained at not less than 0.05MP.

2. The distance between oxygen cylinder and open flame should not be less than10m, and it should not be close to heat source or exposed to sunlight. It should be stored in a dry and cool place, and don't hit the cylinder.

3, oxygen bottle nozzle, inhaler, pressure gauge and interface threads are strictly prohibited to paint (dye) grease.

4. When transporting and loading and unloading oxygen bottles, close the bottle valve, tighten the bottle cap, handle with care, and do not collide, slide or fall. Please pay attention to the protection of the oxygen supply device to the bottle body and valve during moving, parking and use, so as to prevent the gas bottle from toppling and damage the accessories.