Traditional Culture Encyclopedia - Traditional customs - The installation method of balcony drying rack is rather old-fashioned

The installation method of balcony drying rack is rather old-fashioned

Install old clothes hangers on the balcony, referring to the traditional lifting clothes hangers. Here are some ways to install the manual lifting clothes rack:

There are four sets of ceiling pulleys, two of which are single bearings and two are double bearings, and the double bearings are installed near the crank.

The corner device is installed right above the hand crank. The height of the hand crank from the ground is about 1.5m, which can be adjusted at will according to the situation. However, the corner and the crank handle must be vertical, so as to ensure that the wire rope does not rub against the shell of the crank handle during use (if the friction may cause burrs to prick the hand, it may also be worn off).

The method of threading the steel wire rope should be as follows: starting from the corner, one end passes through the bearing at the corner, then passes through the bearing above the double bearing, then passes through the crown block pulley with another single bearing, then hangs down, passes through the lifting ring of the hanger, and is bound and fixed; The steel wire rope at the other end also passes through the bearing at the corner first, and then passes through a bearing under the double-bearing crown block, hangs down and is fastened and fixed by rings. This is the most difficult step to install the lifting clothes rack. It is suggested that qualified children's shoes should find a hanger installer to help them on the hanger installation platform.

Pass the pole through the lifting ring and fix it, then adjust the length of the wire rope at both ends of the pole at the middle position of the wire rope, and fix it on the threaded buckle of the wire rope belt in the handle after the pole is kept horizontal. (Note: Sometimes, because the height of the house is different, the wire rope may be too long, so cut off a part of the wire rope. )

Then plug the ends of the pole, hang the clothes rack and you can install it. (12 expansion screws are divided into four internal expansion screws and eight external expansion screws, which are the top seats for fixing the ceiling. Some styles of windproof hangers are divided into windproof head and hanger body, which need to be assembled together. It will be easy to install the windproof head in boiling water.