10 Introduction of Woodworking Decoration Process

Woodworking decoration technology is widely used, except tables, doors and windows, wardrobes and so on. For such an important part of decoration, I believe everyone is very concerned about the construction technology standards of woodworking decoration in home decoration. Let me give you a brief introduction.

Woodworking decoration process 1: use dry larch or pine as the base of wooden keel, and level it. The specification of wooden keel hair shall not be less than 3cm*5cm. The keel spacing depends on the floor specifications, but shall not be greater than 30mm.

Woodworking decoration process flow 2: the wooden keel of the floor is fixed with dry wooden needles and nails, and the wooden pinhole is drilled with an electric hammer. The drill bit is 10- 12mm, the spacing is not more than 400mm, and the nails are not less than 3 inches. Must be nailed down.

Woodworking decoration process flow 3: The skirting line with clear water paint is laid with 9% multi-layer board as the base, and the edge is sealed with solid wood lines after sticking the board. The height of skirting board shall be constructed according to the design.

Woodworking decoration process flow 4: the skirting line is fixed with wooden pins and nails, the wooden pinholes are drilled with electric hammers or directly embedded with cement and steel, and the spacing is not more than 400 mm, and the skirting line on the wooden keel partition wall is fixed on the wooden keel.

Woodworking decoration process flow 5: The flat door leaf base made on site adopts 18mm thick double-layer wooden door frames, with built-in wooden door frames with a spacing of not more than 300mm, pressed by external veneer, and the width of the wooden door frames is not less than 6cm, and the door pressing time is not less than 48 hours. Between the double-layer blockboard, between the blockboard base and the facing, it should be fully coated with wood glue. The thickness of the edge of the door leaf is not less than 7 mm. Mixing gate is the same as clear water at the grass-roots level, with three layers of plywood outside, and splicing is not allowed. It must be integral or hollow, and there is no need for solid wood wrapping around the door leaf. Except for the special requirements of the owner, the mixed water wooden door provided by Party B shall adopt die-pressed doors.

Woodworking decoration process flow 6: If there are no special circumstances, the decorative painted door and window cover is based on joinery board, the door shovel line is made of 9% multilayer board, the decorative board is attached outside, and the shovel mouth is closed with solid wood line with a thickness of not less than 4 mm ... The specifications and materials of the door and window cover meet the design requirements.

Woodworking decoration process flow 7: the thickness of the louver line is not less than 0.6cm, and the spacing is about 1.5cm.

Woodworking decoration process flow 8: The furniture cabinet door is made of woodwork board or integrated board with the thickness of 15 or 15, and the board made of the same material as the base is built in, and the decorative board is pasted outside, and the door pressing time is not less than 48 hours. The thickness of the edge of the cupboard door shall not be less than 4 mm, the inner and outer decorative plates of the bookcase and wine cabinet must be consistent, and the inner plate of the glass door cabinet should be affixed with decorative plates (except those with special design requirements).

Woodworking decoration process flow 9: gypsum board ceiling adopts Chinese fir keel, joinery board and multilayer board. Spacing is not more than 400mm, and finally fixed with blackhead tapping screws.

Woodworking decoration process 10: the furniture board is made of Chinese fir laminated board or melamine board.

The above are the main points of woodworking decoration construction that I collected from all over the country. After I briefly introduced the woodworking decoration process, did netizens feel more confident when they were doing woodworking decoration? Only by knowing more about the process of each decoration link can we better understand the installation of the house.