How to unlock the lock?

Have you ever locked yourself out? Have you ever locked your things in the cupboard? With a little luck and skill, most common pinball locks can be opened, so before hiring a locksmith, try the following methods to help you pick the lock successfully.

Fine wire lock. Find some wires.

Mix the wires into a cross.

Insert the wire into the keyhole.

Shake the wire up, down, left and right until it locks.

The paper clip is unlocked. Prepare some paper clips.

First, take out a paper clip and bend it into an unlocking tool. Methods: Straighten the circle of the paper clip twice, and straighten the straightened part. As shown in the figure.

Then take out a paper clip and straighten it, that is, make it into a torque wrench. Methods: 1. Bend one end 90 degrees. 2. Straighten both ends until they become two side-by-side iron wires, and press out a 90-degree bend of about 1cm from the bend.

Insert the torque wrench into the bottom of the lock hole and apply rotational pressure to one side. The pressure should not be too great, just a little. If you know the direction in which the key rotates, turn the key in that direction. If you don't know, try both sides once, and there is a half chance of success; If you feel keen, you can feel the unlocking direction by rotating the direction. Turn clockwise first, then try counterclockwise. If you turn it in the right direction, the resistance will be less.

Keep the pressure on the torque wrench, insert the paper clip of the pick lock into the upper keyhole, and start? Looking for a position? . This part is to insert the lock picking tool into the bottom of the lock hole, stick it on it and pull it out quickly to try the internal structure of the lock. Repeat several times and move some pins inside.

Keep the wrench pressure and try to find out the position of the bolt with the lock picking tool. Most American locks have at least five latches, and all of them need to be tried to open.

Try the bolt position one by one from the inside, and press. Remember to keep the wrench pressure when doing it, and press the bolt to the unlocked position, you will feel a slight elasticity and even hear a slight click. Experienced locksmiths can do it at once, but novices need to try to open all the bolts slowly.

Apply more and more pressure with a wrench. Every time you touch the latch, shake the lock pin until the latch opens. Remember to turn the wrench to unlock when you hear the click.

So the lock was opened. Don't use it to unlock the lock illegally, it will bear criminal responsibility! )

The wrench is unlocked. Prepare two wrenches.

Put the wrench on the lock so that the two wrenches are opposite.

Hold the wrench handle with both hands and clamp the lock firmly.

Then the lock popped open.

Card Unlocking If there is a card with a lock at home, you can draw the key and the card by comparison, and then cut it out with scissors. You can also try to unlock them. Note that when choosing a card, you must not choose a card that is too thin, but a card with appropriate thickness.

When choosing aluminum to unlock, it is best to have aluminum at home, but we can operate with cans without aluminum.

Cut a piece of aluminum with scissors.

Insert a small piece of aluminum from the jar in the direction of the lock, and the lock will open easily.