What is atomization?

Atomization is a tattoo method, which starts from two aspects, one is the penetration depth, and the other is the density between needle marks. The two need to cooperate in order to obtain the ideal effect in practical application.

The speed of manipulation should be accelerated, the frequency of tattoo machine should be accelerated, the speed of manipulation should be slowed down, and the frequency of tattoo machine should be accelerated. Stable machine frequency should be matched with stable manipulation speed, so that the needle marks left by each action are consistent. This is also the key to make the fog surface uniform.

Tattoo technique

1, the length of the needle must be controlled at about1.5 mm. If the scale of the buried needle is not well grasped, it is easy to cause pigment accumulation and halo. This is not conducive to the next operation.

2. Don't adjust the machine current too much when trimming, otherwise it will be difficult to grasp the depth of the buried needle when trimming. The key to the depth of the needle is the strength of the hand, followed by the depth of the needle according to different parts of the skin.

For example, the needles on the upper arm, shoulder, hip and inner clavicle of thigh should be shallow, otherwise it is easy to faint, and the needles on the back of hand should be deep and easy to faint. In addition, if you don't make small patterns that are too fine, it is best not to use fine needles (three-round needles).