How to replace t4 tube with LED strip?

Remove the old fluorescent tube, that is, there are springs on both sides, and you can come out with a little push, and the same is true when installing. Then take off the cover plate of the bracket, press the bottom plate with your left hand, and pull up the cover plate with your right hand to take off the cover plate. Then disassemble the electronic ballast, cut the input and output lines of the electronic ballast with diagonal pliers, and unscrew the screws for fixing the electronic ballast with screwdriver, so that the electronic ballast can be easily disassembled. Then connect the wire of the power grid with the entrance of the bracket and wrap it with electrical tape. Cover the cover tightly, straighten the wrapped wire and fix it in the bracket slot. Hold the cover plate with both hands and press it down hard to cover it tightly. Finally, install the LED lamp tube, align the wiring pins at both ends of the LED lamp tube with the mounting seam of the bracket, and you can easily put it in for installation.