Do you have handmade square cloth shoes and sizes suitable for two-year-old babies?

Material: 1. Cotton, you can choose some clothes that are idle at home.

2. Small embroidery needle. Personally, I think it is better to choose a thinner needle.

3. For the thread with similar color to the cloth, I used the remaining thread in cross stitch.

4. prepared paste, this is very simple. I'll tell you how to prepare it.

5. Buttons or matching trinkets can decorate shoes according to your own ideas to make them more exquisite.

6. thimble pin, worn on the ring finger to help puncture, I have never used this, so my hand is worn out.

(1) Prepare the paste, add a little cold water to a teaspoon of flour, and stir it in one direction with a spoon while cooking on low heat until it becomes a paste, which is a bit like porridge.

(2) Choose the idle cloth at home and cut it into two pieces. Apply paste to the front and back of the cloth. Fold two pieces of cloth together, align them and stick them on the hard board. Fold two pieces of cloth together and flatten them. Wipe off the excess paste from the cloth. Air drying. Don't forget to leave some salt-free cloth for piping.

(3) Cut it into the following shapes with a waste paper box, which can be cut according to the size of the baby's feet. You can use strokes to express the appearance first, and fold the paper in half to trim it (just trim it neatly, remember to trim it smaller). Must be symmetrical.

(4) Fold the pasted cloth in half (shrink it into a pair of shoes at a time), put the cut pattern on the pasted cloth, sew the pattern and the cloth together with a needle and thread (it can be fixed by sewing a few stitches at will), then cut the cloth into a pattern shape along the pattern and remove the pattern.

(5) Cut the cloth into strips half a finger wide, the longer the better, and roll the surface and foundation.

Curling method:

1. The front of the cloth strip is opposite to the front of the surface (base) and sewn.

2. Turn the cloth strip over and flatten it, turn it inside, roll the edge of the cloth in and sew it on. The distance between the threads passing through the outside should be uniform, and the distance between the threads inside can be ignored. Be sure to tighten the cloth strip and stick it on the starched cloth sample when sewing.

(6) The base coat should have one more layer of cloth than the surface coat, then subtract two layers, sew it on the base coat with hemming and sew it inside!

(7) Fold the front side in half with the reverse side facing outwards, align the tail and sew the tail.

(8) Fold the face and the bottom in half respectively, and fix the midpoint of the front and back of each fold together with a needle and thread.

(9) Then sew the front and bottom, using the same side stitch method.

(10) Finally, turn the shoes upside down and buckle them. Creative friends can also add some beads to decorate it.