How to make a plane bracket by hand

Tablet computers are easy to hold, but sometimes they are soft. Sometimes I want to put it on the table or on the ground to watch movies. Then make your own scaffolding.

Tools/raw materials

Saw, adhesive tape, lighter, carton.

Methods/steps

Here, the paper box is selected as the bracket. First, find a cardboard box of suitable size and draw two lines 3 to 4 cm from one end. The width of the groove here shall not exceed 1cm (the width can be increased according to the inclination).

Then cut a V-shaped groove on the paper box with a saw and smooth it with a knife. The depth is about 1cm.

Then put the flat plate on it to see if it is stable and adjust the tilt angle. If you want to stand upright, the groove should be deep, if you want to tilt the groove, you should widen it appropriately.

Then the carton is easy to break, so tape should be attached to the slot to prevent the weight of the flat plate from prying open the carton.

Next, open a hole on the right side of the paper box. This paper box can put a mobile power supply in it, which will be more beautiful. The position of the hole depends on whether the flat plug-in port is on the left or right (generally, the screen can rotate, so it doesn't matter).

After slotting and opening the carton, you can burn some scraps of paper on the carton with a lighter, which will reduce burrs.

Then put the mobile power supply into the paper box, take out the cable, plug in the tablet computer and put it away. After watching a movie, there is no problem.