Fishing rods, hand rods converted to iso rods?

It is recommended not to change. Change iso rod can only do recreational fishing; joint strength is not enough, the rod to be particularly careful, do not recommend far casting; change is not good to use, even if the use of the standard over the line ring, put the line due to the node is long and not free, especially in the water. Sea fishing is not far from casting, 4.5 is still OK.

To modify the tools: vernier calipers, triangular file, 502 glue, AB glue, transparent glue, about 2 meters of red line tied to the explosive hook or similar line.

1. first calipers to measure out the outer diameter of each section and make a record, precision 0.1 mm, of course, is to be equipped to install the wire ring at one end of the measurement, that is, the thin end. The grip section should not be fitted with a wire loop, so of course this section does not need to be measured. In the middle of the first and second section, a movable loop is installed, so a measurement should be taken in the middle of the first and second section. Since the rod is modified from a hand rod, which is softly tuned, it is recommended to remove half of the first section to get a better result.

2. Take the measured data to the fishing tackle store, buy all the needed over the line ring, it is best to go to a larger store, in a place with all, this thing from 0.2-20.0 mm specifications are available, if a certain type of real and then can not be matched, can also be matched with a small 0.1 mm specifications of the over the line ring, the smallest installed on the tip of the rod the ring should pay attention to the shape of the ring, you want to buy and the sea rod over the line ring shape style. . The price of 1-2 yuan, different markets around the difference, the material should pay attention to, buy a magnetic inner ring, do not buy pure metal. Don't forget to buy a reel card holder.

3. to each section of the installed over the line ring at the paint scraped off, scraped in the back of a little wrapped in transparent adhesive, so that scraped out of the gap neatly, but also this tape can be installed over the line ring on the glue to avoid the glue flow to the rod body affects the aesthetic.

4. Installation of the wire loop. If you want to clean it before installing it, you can't pull it out and clean it after installing it. Installation of the first to install a large over-wire ring and then install the small, the order can not be done in reverse, otherwise installed on the small, the large can not be installed. Each loaded with 502 reinforcement, the amount should be appropriate, more will be piled up, less can not achieve a solid effect. If a wire ring is too small to fit, use a triangle file to scrape a few rounds, the inside of the glue scraped off a little after the installation.

5. In the handlebar on their own feel the appropriate position to install the wire wheel card, too front feel heavy, too far back the operation of the inconvenience, the wire wheel card is best to buy with a rubber pad. First use the line to tie the card fixed, like tying the hook method of tying, so more tight and smooth. After tying, you can use 502 to reinforce it, if you think your line looks good, you can stop here. The end.

6. Add AB adhesive to the card base fixed,

This whole process is completed.