Excuse me, how to connect the stereo to the old amplifier?

The two speakers are connected to the "left channel" and "right channel" on the back of the power amplifier respectively. Pay attention to the positive and negative poles. If you see the speaker cable, you can't find it and need to buy it. Depending on the placement of the speaker, the length is slightly increased.

Input audio sources are VCD, CD, DVD and tape. This is an audio source. For example, for a VCD, connect the output on the back of the VCD with the lotus plug line in the picture, usually a red and white lotus socket.

Follow the above steps to connect and you can use it.

The home stereo is a two-channel stereo system. There are two independent amplifiers in the amplifier, which drive two speakers to play back the sound source information of the left and right channels respectively, and there is no master-slave distinction. Just put one on the left and one on the right.

Don't connect two speakers in series and parallel, as this will make two speakers connected to the same channel, and the other channel will be idle, which may cause problems. Just connect the lines of the two speakers to the L(+/-) and R(+/-) terminals of the amplifier SPERKEROUT respectively. Pay attention to the same polarity, that is, the red end of the speaker is connected to the red end of the power amplifier, and the black end is connected to the black end of the power amplifier, and vice versa, but the two speakers should be unified.

For more information about how to connect stereo to the old amplifier, please visit:/ask/1989 301615640548.html? Zd view more content