Can Langjun t5 fluorescent lamp bracket be replaced with led lamp?

The main difference is that the built-in bracket and the interface are different. For example, the fluorescent lamp T5 uses an electronic ballast, and the LED uses a constant current. It is definitely not possible without replacing the bracket. It is definitely possible to change the brackets together, and the lines are all parallel.

It depends on the voltage of the lamp. If it's AC 220V, don't worry. The rectifier and starter are mainly removed and directly connected to the second stage. If it is low pressure, a special bracket is needed.

The strength is the same. If you can install it, you can use it.

If you don't want to start the circuit, just remove the starter. In this way, the original inductor is also consuming power. If you want to save energy, just connect the two ends of the bracket to 220 volts, and the LED tube has a built-in power supply.

T5 tube is a kind of fluorescent lamp (or fluorescent lamp, fluorescent tube and cathode fluorescent lamp), which is not good, consumes too much energy and has low efficiency. The efficiency of converting electric energy into light energy is only 40%, and it will be eliminated sooner or later. Energy-saving lamps are used now, and there are T5 energy-saving lamps at present.

The circumference of T5 fluorescent tube is 5cm, and that of T8 fluorescent tube is 8cm. If the two lamps have the same length, the power of T5 is smaller. If tricolor phosphor is used, the luminous efficiency of T5 is higher, which is not worse than that of LED (average level).