Weaving process of hand-woven scarf

The knitting process of hand-woven scarf is introduced as follows:

Preparation materials: wool and knitting needles.

1, prepare your favorite wool and sticky needle, tie the wool loop in a slipknot and put the sticky needle in the slipknot.

2. Then wrap the wire with your fingers and put it on the stick needle, starting with 20 stitches at a time.

3. Then, start knitting on the next stitch, so that the knitted edge will not roll up.

4. Finish knitting this row and turn it over. The first stitch was not picked, and the second stitch began to knit.

5. Then repeat knitting in this way. In the process of knitting, the strength of the finger belt line should be the same, and the stitch method should be the same, so that the knitted scarf will be very flat.

6. Weave a few more rows, and the threads of these two colors will feel like blue sky and white clouds.

7. Then continue to knit to the length you like.

Hand-woven scarf method is as follows:

1, prepare materials. For beginners, it is very important to choose the right material. The length of your scarf is about 1.5m, so you should prepare at least two rolls of terry about 1m, an H-shaped crochet, a darning needle for finishing and scissors.

2. Hold the needle correctly; Although everyone holds the crochet in different ways, most people choose to hold the pen, with the thumb and forefinger holding the flat part of the crochet, and the other fingers shrinking behind. Remember to hold the needle in your right hand, wind the thread in your left hand and hold the scarf.

3. Start the first knitting. To knit the whole scarf skeleton, the first step is to make a self-locking slipknot on the crochet. The method is as follows: take a wool and wrap it around the index finger about 2.5cm away from the fingertip.

Thread the thread on the finger surface out of the ring at the intersection to form a second ring, pull the index finger out of the ring, tighten the second ring and tighten the slipknot; Hang the knotted knot on the crochet, and adjust the tightness of the slipknot by pulling the wool.

4, knitting a first lock needle; Lock the thread of the left hand with the hook of the right hand, then tighten the thread of the left hand, wrap it around the hook and hook it with the hook; Pull the crochet and crochet together from the slipknot made in the first step.

5. Weave nail plates. The method of knitting scarf nail plate is the same as that of knitting lock needle. The length of the nail board can be 12 to 18, depending on how wide you want to knit the scarf.

To add a lock needle, just repeat the previous step: tighten the wool, wrap it around the crochet, hook the thread, pull the thread out of the original loop to form a new loop, and repeat the crochet in turn. Each crochet is recorded as a lock needle.