Wooden door installation need to master the skills, so you can get twice the result with half the effort

In ancient China, wooden doors are basically the basic configuration of every family. Whether poor or rich, there will be. Now, with the development of the times, the development of the door material has begun to diversify, but the wooden door still occupies the mainstream market. Below, we bring an easy introduction to common wooden door installation tips, so you know the process of installing wooden doors.

A, installation prerequisites

Wooden doors must be used to retain the hole installation method, prohibit the installation of the side of the mouth of the practice. Wooden door must be installed in the installation of the hole in the ground project installation is completed, while the wall putty scraped and polished plane before the installation work.

Two, the use of tools

Should be ready to prepare all the electric hammer, woodworking hammer, planer, flat file, fine-toothed saws, screwdrivers, tape measure, tape measure, hanging line hammer, level, drill, hole opener, poke, the corresponding specification drill bit.

Three, formal installation

1. Door cover

First of all, according to the figures on the back to find the door cover and the vertical plate, good joints, in the same plane on the same, in the interface application of glue.

Place the assembled door cover as a whole into the door hole. Use small wooden strips to secure the door cover around the door. The door cover should be on the same plane as the wall. Then check that the cover is plumb and the floor is vertical. Do the top plate of the door cover and the two brackets regardless of whether both corners of the plate are at right angles, and whether the door plate is bent and the ends of the iron pieces are twisted to wrap it around the wall.

2. door

First open the hinge groove, hinge groove, the distance between the two ends of the door is 1/10 of the height of the door is appropriate.

3. Door lock

Check the door, door lock switch is flexible. Very flexible. Joints in line with the norms.

4. Door casing line, door suction

Cut the door line into a 45-degree angle with a straight edge, use a woodworking planer to trim the, right angle to the door pocket, and use flooring adhesive to connect the door casing line to the door panel. Then fit the door inhalation in the corresponding position.

5. Inspection and Cleaning

Check whether the door components are intact. And try to open the door page door lock to see if it is solid and working properly, if there is no problem, then you can carry out on-site cleaning after completion.