How to mark the vertical bars on the floor reinforcement drawing

It is in-situ marking, for example, in a floor reinforcement drawing in a plate on a cross line, and then in the longitudinal line marked ① Φ8@150, in the direction of the transverse axis marked ② Φ10@180, and then in the other plate is ③, ④, etc., and then in the other plate, if there is a previously appeared in the same spacing rebar type Then in another plate, if there is a rebar type with the same spacing, then only the rebar serial number on the crosshairs is ①, ②, ③, etc. The same applies to the negative moment bar. Negative moment bar is the same, in the adjacent 2 boards in the intersection of the place to draw a cross line, the cross line at both ends of the short vertical line down, and then in this cross line has a similar ① Φ8@150 labeling, and the plate reinforcement is different from the cross line is usually the left and right sides of the different boards have a similar number of 1500 1200, the figure represents the length of the negative moment bar buckled in the 2 boards when needed.