Knitted sweater sewing video

The method of sewing the edge needle of sweater is as follows:

1, when the sweater is knitted to a satisfactory length, stop knitting, and leave 2-3 times the residual thread length according to the width of the sweater to prevent the subsequent sewing from being insufficient. First pick the front needle with the right needle and thread it with the left needle.

2. Knit the second needle with your right hand.

3. Cover the left needle tip with the first eye of the right needle.

4. Pick out the first needle from the second needle.

5. Thread the selected thread on the right needle and repeat the same action with the left needle. This is how flat needles are played. Take a flat needle, pass the sweater needle of the left hand through the only two flat needles on the sweater needle of the right hand, then lift the thread and put it down. Keep repeating.

6. Every stitch is like this until the left stitch has no thread and the right stitch has only one stitch.

7. At the last stitch, lift the whole wool, pull the wool by hand and tighten it to finish the edge locking.

The second method:

1. Draw a line where the edge needs to be wrapped, and determine the number of stitches for drawing the line according to the situation. Generally, two long lines should correspond to five needles.

2. After the drawing is completed, hook the short needle back and forth in Lishan and pull out the braid.

3. That's it.

Basic elements of bundling needle:

You don't have to use two sticks. The advantage of raising the needle with two sticks is that the eye of the needle is relatively large, which makes it easier to insert when knitting the first row, but the hole of the eye of the needle is relatively large, which may not look good. You can also use a stick needle to start the needle, but some people pull it too tightly and it is difficult to start the needle when knitting the first row, so if it is tight, you can use a stick needle to start the needle.