Installation diagram of flush valve of squatting pan

In many schools and hospitals, as well as in many public places, toilets are equipped with squatting pans. Compared with the toilet, the squatting pan conforms to the habits of most people in China, and it also has the function of flushing. The flush valve of squatting pan is the key to flush squatting pan. If the flushing valve is damaged, it will not flush normally. Although we often flush with squatting pan, we don't know much about the installation of flushing valve. The following is Bian Xiao's detailed introduction to the installation steps of the flush valve of the squatting pan.

Installation steps of flush valve of squatting pan:

Installation steps 1. First of all, we should prepare common materials and tools, such as raw material tape, glass glue, sludge, tape measure, spirit level, etc.

Step 2: According to the sewage outlet of the installed products, reserve the sewer pipe at an appropriate position far away from the wall, and determine the distance between the entrance of the sewer pipe and the ground.

Installation step 3: the depth of the pit reserved under the ground for installing the squatting pan is greater than the height of the toilet.

Step 4: Put the connecting rubber plug into the water inlet hole of the squatting pan and clamp it. Coat a layer of glass glue or putty on the outer edge in contact with the water inlet of the squatting pan, and put the glue into the water inlet to make it seal well with the rubber plug to prevent water leakage.

Step 5: Coat a layer of glass glue or putty on the edge of the water outlet of the squatting pan, put it into the inlet of the sewer pipe and tighten it, and erect the toilet horizontally with cinder or other fillers.

Step 6: Open the water inlet system and check whether there is water leakage at each joint. If there is water leakage, check the situation at each joint. Until the problem is solved.

Installation step 7. After checking that there is no water leakage in each joint, fill the periphery of the toilet with filler and fill the contact surface between ceramics and cement mortar. 1cm？ Than elastic materials such as asphalt or linoleum.

Installation Step 8: Fix the squatting pan on a horizontal surface with cement mortar, and then lay the bathroom floor tile on the cement surface after it is stable and firm. Try to rinse it, and use it if there is nothing unusual.

Squatting toilet refers to a toilet characterized by squatting when used. Squat toilets are divided into unobstructed type and sheltered type; The structure of squatting pan has bending back and no bending back.

Through the above introduction, I believe everyone has a certain understanding of the resolver flush valve and its installation steps. The flush valve of squatting pan is a very important part of squatting pan. If there is something wrong with this part, the squatting pan cannot realize the most basic flushing function. Bian Xiao suggested that when installing the toilet flush valve, you must choose a professional installation company to install the toilet flush valve, so as to avoid the use failure of the toilet flush valve due to installation problems. I hope Bian Xiao's introduction can help you understand the installation steps of the flush valve of the squatting pan.