How to construct embedded lamp trough

The installation method of embedded lamp trough is as follows:

1 First of all, we have to cut off all the power supply and cut it off on the lamp body of the light strip with scissors. If it is not cut off, it is likely to cause a unit not to light up. When installing, bend the lamp strip to one side to expose the copper wire for 2~3 meters, and then cut it clean with scissors without leaving any burr. If there is burr on the wire, it is likely to lead to short circuit in the later stage.

2, in the process of installation, can't electricity, after the installation is correct, the installation can be connected to the power supply.

3. If the temperature is low in winter, when installing the embedded lamp, you can turn on the power for a few minutes to soften the lamp body, and then turn off the power, which will soften the lamp body and make the installation easier.