Reconstruction scheme of traditional air outlet

The following preparations should be made before the transformation of central air conditioning:

1. First, let a robot with a camera enter the central air-conditioning pipeline, check the specific situation in the pipeline, and then proceed to the next step.

2, carefully check the central air conditioning pipeline design and installation drawings, formulate detailed pipeline reconstruction plan, and with the consent of the customer, and then implement.

3. Open two holes in the proper position of the air duct of the central air conditioner, and then block both ends of the pipeline with sealed air bags at the positions of the two holes.

4. Connect the vacuum cleaner in one of the construction holes with a suitable hose to generate negative pressure airflow in the air duct and suck all pollutants and dust in the pipeline into the vacuum cleaner.

5. After suction, choose a suitable cleaning soft shaft brush to clean the pipeline, or use the pipeline cleaning robot to complete it.

6. After the cleaning work is completed, take photos of the cleaning situation with the robot to confirm the cleaning quality.

7. If the cleaning quality is up to standard, the pipeline should be disinfected with ultraviolet rays to avoid secondary pollution.

Finishing work:

1. After all central air conditioners are cleaned, the site should be carefully cleaned to ensure the smooth progress of the next step.

2. Next, the site is restored. Since the seal was removed during the cleaning process, it should be reinstalled at this time and the size of the air outlet should be adjusted to ensure that the air output is moderate.

3. After all this is finished, the cleaning of the central air conditioning pipeline is successfully completed. At this time, the details of the construction will be sorted out and handed over to the customer, and everything will be done.

What problems are prone to occur in the central air conditioning pipeline?

1, pipeline welding is unreasonable, mainly including the following points:

The slope of welded joint is unreasonable.

The welding process is unreasonable, and the root is not melted and incomplete.

Cracks in the weld lead to the destruction of the welded joint.

2. The pipe is blocked, and the common reasons are perforation during welding, which leads to flash in the pipe; Debris accumulation and so on.