Traditional Culture Encyclopedia - Traditional festivals - How to adjust the drift of the floating beak, how to adjust the drift of the floating beak

How to adjust the drift of the floating beak, how to adjust the drift of the floating beak

I don't know what fishing method you use. Generally speaking, it is nothing more than Taiwan fishing and traditional fishing!

Fishing in Taiwan Province:

1. Assemble the wire assembly and install the float and double hook. The float is about 30 cm away from the sub-line. Add lead (extra) to the lead base and pull the float into the water.

2. Adjust the distance between the float and the auxiliary line until the float is 1-2 mesh above the water surface (find the bottom).

3. Pull the float up 20 cm, and then the float will sink to the bottom again.

4. Cut off the lead skin gradually with scissors until the floating tail reveals the desired mesh (for example, 3 mesh or 4, 5, 6, 7 mesh). This mesh is the number that has been dialed several times. The specific mesh number should be comprehensively considered according to the performance of the float you use, the target fish, the season, the severity/fierceness of the fish mouth and many other factors. Remember to wrap the lead cover tightly on the lead cover seat after adjustment.

5. Double hook bait (feeding), note: keep the general size of each feeding. At this time, the float will sink into the water again under the gravity of the bait, and gradually adjust the float until the tail of the float comes out of the water to reach the number you want. This number is the number of "catches" that have been adjusted several times. For example, if you show your eyes, you will catch 1.

6. The above are the most basic bleaching methods, so you should learn so much first. The so-called "four fishing and two fishing" is a simple formula set by the earliest dharma drift, which is not suitable for the current fishing method. The specific adjustment of several catches needs specific analysis. This is a complicated theory. Take your time.

Suggestion:

1. Float is made of balsa wood or reed.

2. Floating-point numbers should be between 0 and 2 and should not exceed 2.

3. Start with rubbing the bait, and don't practice pulling the bait too early.

Traditional fishing methods:

1. Pull the float closer to the hook (it can be pulled to the bottom);

2. Throw the float into Hanoi and observe the state of the float;

3. If the fish floats into the water, it means that the lead skin is heavy, and vice versa;

4. Increase or decrease the lead skin with small scissors until the tip of the float floats up and down on the water surface; That is to say, at this time, the fish float is upright in the water, and the fish tip floats up and down in Shui Pi. Adjustment completed.

5. Pull up the float gradually until the tip of the float shows two eyes (where you want to fish) and find the bottom.

6. Take the bait and start fishing.