Motorcycle lock circuit schematic

1, each brand of each series of motorcycle lock circuit principle is different.

Two, choose a good motorcycle locks

1, see the surface clean and flat, no bumps and bruises, scratches, flying edges, burrs, cracks, casting holes and other defects affecting the appearance of the locks quality and performance.

2, test the electric door lock is clear gear, good conduction, in line with the logical requirements.

3, the tank lock relative to the tank on the surface of the height of the projection should not exceed 15mm and its surface should be smooth, if greater than 15mm should be a protective device.

4, with a gauge to measure the size of the allowable tolerance range.

5, in addition to the conditions of manufacturers to do some endurance test, anti-salt spray test, vibration test.

Extended information:

Motorcycle power lock: that is, add a lock to the power switch.

Power locks are widely categorized:

A. According to the voltage, it can be divided into low-voltage power locks, high-voltage power locks.

Low voltage power locks are mainly used in some small electrical appliances, electric toys, electric cars.

High-voltage power locks are mainly used in machine tools, elevators and so on.

B. According to the size: large power lock, small electric original lock.

Large power lock, mainly refers to the diameter of 18 mm and above size of the power lock

Small power lock, mainly refers to the diameter of 12 mm power lock.

C. According to the circuits that can be controlled, it can be divided into single-circuit power locks, double-circuit power locks and multi-loop power locks.

Single circuit power lock; means it can only control one circuit.

Double circuit power lock: it is the power lock that can control two circuits at the same time. This type of lock has two kinds of locks: double pass and double break, and one pass and one break.

Double pass double break power lock: refers to the two circuits at the same time power on, power off.

One pass, one break power lock: refers to the two circuits, there is always a break, a pass, can not pass at the same time or at the same time disconnect.