Please ask the specific process of circumcision is how to do ah the more detailed the better, thank you!

You want to circumcise

Pre-operative preparation 1.

The night before the operation and the day of the operation, the patient is instructed to wash the local. Clean the genitals: from 3 days before the operation, the genitals should be soaked in warm water or 1:5000 potassium permanganate solution every day. When cleaning, the foreskin should be turned over to expose the coronary groove, and the foreskin scale should be removed thoroughly. However, it should be noted that the cleaning should be completed in a timely manner to reset the foreskin, so as not to cause YJ foreskin inlay.

Pre-operative preparation 2.

Complicated foreskin, GUI head inflammation, need to choose drugs and local immersion treatment, inflammation subsides before surgery.

Pre-operative preparation 3.

Eliminate nervousness: Because the wound will be a little uncomfortable in the first few days after the operation, some people are worried that the operation will have an effect on the sexual function, and this kind of idea is unnecessary. Generally speaking, circumcision will not affect normal sexual function. On the contrary, if the burden of thought, but may cause mental sexual dysfunction.

Pre-operative preparation 4.

Before circumcision, it is best to fast for 4-6 hours, otherwise it will cause discomfort.

Cleaning and disinfection:

Wash the local area with soapy water and saline, disinfect with 1:1000 Neosporin solution; circumcised people with a syringe connected to the vein incision needle will be injected into the foreskin capsule to disinfect the Neosporin solution.

Anesthesia

YJ root subcutaneous and both sides of the spongy anesthesia.

Separation of adhesions:

In the case of narrowing of the circumcision and adhesion of the foreskin to the head of the YJ, the circumcision is first enlarged with a hemostat, and then the dorsal margin is clamped with two hemostats right at the middle of the dorsal margin. A slotted probe is used to separate the adhesions until the GUI head is completely separated from the foreskin. The foreskin sac and YJ head were then cleaned with sterilized saline.

Designing the incision:

Clamp the foreskin at the prepuce tie with a hemostat to lift the foreskin. The tip of the knife is used to make a cut in the outer plate of the foreskin at 12.5 px distal to the coronal margin, ready to be used as a circumferential incision, to prevent over-excision.

Dorsal incision:

The inner and outer foreskin plates are cut with scissors along the proboscis grooves, and the inner foreskin plate should also be cut to approximately 12.5px from the coronal sulcus margin.

Excision of the foreskin:

Align the inner and outer foreskin plates, pull the hemostat clamped to the dorsal side of the foreskin and the tethered ligament outward, and then review the appropriateness of the outer foreskin plate incision as a circumferential incision. If appropriate, use curved scissors to cut the right skin flap along the incision approximately 12.5 px from the coronal sulcus and then cut the left side. The inner and outer flaps at the circumcision tie may be left uncut or retained more.

Hemostasis:

Hemostasis is achieved by retracting the YJ skin upward to reveal the bleeding point, and special attention should be paid to ligating the dorsal superficial vein of the YJ right at the dorsal side of the YJ

Suture:

Use a fine silk thread to first close one suture in each of the dorsal, ventral, left and right of the circumferential incision, and do not tie the ligature too tightly so as to avoid strangling the skin in the event of edema of the tissue. The sutures are not cut short, and are left to hold the dressing in place. Then use every two stitches between the suture 1 to 2 stitches, the suture should be close to the cutting edge through.

Dressing:

A strip of petroleum jelly gauze is placed around the circumcision, secured with sutures left long, and then wrapped with several layers of gauze.