Stained glass construction process

Color glazed glass construction process

1, color glazed glass construction process: grass-roots level cleanup → standing bar → pouncing nail liner → glass installation

2, color glazed glass specific construction process

(1) wall combination of color glazed glass, should start from the bottom, according to the position of the bullet line upward step by step to paste, and in the block and the block of the seam of the glass adhesive coated with a small amount of; for the installation of large blocks of color glazed glass should be used in accordance with different installation process

(2) embedded pressure type installation of color glazed glass should first be fixed using wood press bar, and the corresponding process should be used. Large stained glass installation, should be in accordance with the different installation, using the appropriate technology

(2) embedded pressure type installation of stained glass is, should first use the wood pressure strip fixed, can use 20 ~ 25mm nail gun nail fixed, avoid the use of ordinary round nails broken stained glass; aluminum and stainless steel pressure strip can be used in the nail process that is, the first wooden liner card stained glass, and then use the adhesive will be the pressure strip stuck in the wooden liner, and then the pressure strip in the wooden liner, and then the pressure strip in the wooden liner. Then use the adhesive to stick the pressing strip on the wooden liner, and then seal the glass glue at the corner between the pressing strip and the colored glazed glass.

(3) glass nails fixed installation, each glass surface drilling four holes should be evenly arranged, and not too close to the edge of the colored glazed glass, to prevent the colored glazed glass chipping. Screwed into the glass nail should be tightened to the corner, to the glass does not shake prevail, screwed in the nail on the decorative cap.

(4) paste plus glass nails double fixed installation, more suitable for some important places, or glass area greater than 1m2 top, wall and column surfaces, to ensure that the glass mirror in the crack will not fall hurt.

(5) Colored glaze glass in the corner of the wall and column surface should be line crimping, or grinding edge diagonal, or with glass glue and other methods of articulation to meet the design requirements.

(6) color glazed glass directly with the building substrate installation, such as its substrate is not flat, should be re-plastered, or add wood plywood substrate. Before installation, should be in the color glazed glass back paste kraft paper protective layer, line and glass nails should be nailed to the buried wall on the wooden wedge.

(7) After the installation, should clean the color glazed glass, if necessary, in the color glazed glass surface overlay with a protective layer, in order to prevent damage.