Casting rod how to load line and drift the whole process

The whole process of installing line and drifting on a casting rod is as follows:

First of all, you need to prepare the fishing rod, fishing line, space beans and other tools, and then fold a section of the fishing line in half, put a space bean through, and tie a knot on the top as well as on the bottom, and tighten the knot when it is loose. Then fold a loop in the center, thread one end of the line into the other end, pull it tight, then move the bean up, and finally secure the knot. Be careful when tying, none of the knots should be too loose, they all need to be tighter.

Fishing rod how to load line

Fishing rod is the main tool in fishing, can also be said to be the most important tool. After getting the right fishing rod selected, the next important task is to load the fishing line onto the rod.

This means that the first thing you need to do is to get the right fishing line ready. The most commonly used type of fishing line is nylon line, so be careful to choose the right type according to the fish and water conditions. After all the tools are ready, you can start the specific installation. Fold a section of the line in half and thread a space bean through it. Above and below it you need to tie a knot each.

Sometimes, these two knots are not particularly tight and are rather loose, at which point they need to be pulled tight and not too loose. Then, in the middle of these two tied knots, a loop needs to be stacked. The two ends of the double line need to be dealt with, one end of the double line clamped into the other end, also need to pull it tight. At this point, the position of the space bean also needs to be changed, and it needs to be moved up. Finally, just secure the knot.

How to fit a float to a fishing rod

The process of fitting line to a fishing rod has already been described above, and the other thing that needs to be done is the process of fitting a float. The first thing that needs to be done is to have the right fishing rod as well as the float ready. Fishing line is also an essential tool at this point. A space bean will be installed first, then the float seat, and another space bean will be installed.

One of the beans is to hold the seat in place and the other is to adjust the depth of the water. Let these two space beans clamp down on the center drift seat so that it is held in place.

On top of the float seat, there is a hole that is needed to mount the float. Simply fit the prepared float in this hole. Then, another space bean needs to be installed, and this one will be able to work with the two previously installed ones, so that the float can be fixed a little better. After installing the float and making all kinds of preparations, you can basically start fishing.