Frameless glass windows Specific installation methods

1, positioning: frameless glass door in the beginning of the installation, it is necessary to fixed glass partitions and activities of the glass door fan uniform positioning, to determine the position of the door frame, accurately measure the ground elevation and the top of the door frame elevation.

2, the installation of frameless glass door door frame top limit slot: by playing the center line leads to two metal decorative plate edge line, and then according to the edge line for the top of the door frame limit slot installation.

3, the installation of frameless glass door metal finish wood bottom bracket: in the original pre-embedded wood tiles nailed to the square wood, or through the expansion bolts nailed to the square wood, the square wood is fixed to the ground, and then use the universal adhesive will be metal decorative panels glued to the wooden square.

4, the installation of firm to the door frame: according to the pop-up center line nailed door frame square wood, and then use plywood to determine the dimensions of the door frame columns and the location of the fixed, when fixed, and then wrapped metal decorative surface.

5, frameless glass door glass door installation: glass suction cups (or glass suction cups machine) to the thick glass suction suction, and then hold the suction cups put through 2 ~ 3 people to lift the thick glass plate and stand up and move to the installation site ready to be in place.

6, glass fixed: in the bottom bracket wood inside and outside the nail two flat square wooden bar to the thick glass clamped in the middle, but the distance from the thick glass plate need to leave a gap of 4mm or so, and then in the flat square wooden bar on the brush universal adhesive, will be decorated with metal plate sticky card in the square wood and the two flat square wooden bar.

7, injection of glass sealing: in the top of the root slot on both sides of the gap and the bottom of the glass groove on both sides of the bracket, as well as the thick glass and the door frame columns of the seam injected into the glass glue.

8, frameless glass door between the glass butt: fixed part of the thick glass plate, due to the width of the size is too large, must be assembled with two or more than two pieces, two aligned splicing is bound to form a seam, the seam should be left a distance of 2 ~ 3mm.

Expanded information;

Frameless glass window features;

1, balcony frameless glass windows with good lighting. Experimentally tested, the lighting effect of the pitched roof window is more than 10% higher than the average window. The light can be turned on one hour later every day. At the same time can enjoy the night stars, add interest.

2, balcony frameless glass window insulation and heat preservation. Slanted roof skylight using insulating glass heat transfer coefficient is 2.5-4 times smaller than the average glass. Some people have done experiments in the hot season in Guangdong, in the same environmental conditions, the general glass window indoor 10 times a day to open the air-conditioning unit, while in the room equipped with insulating glass as long as.

3, balcony frameless glass windows soundproof noise. Slanted roof skylight insulating glass can block out more than 30 decibels of noise.

4, balcony frameless glass windows sloped roof skylight adopts the center rotating opening method, which is convenient for the airflow to rotate back into the room, even in the winter season, it will not make the cold wind on the face, but softly make the indoor air become fresh; it is convenient for the opening and closing of the skylight and the cleaning of the inner and outer glass.