What to look for when punching holes in ceramic mugs

1, in the ceramic cup when punching holes, not 100 percent can be successful, playing a bad or ceramic cup material is not good, may be playing burst off.

2, in order to increase the success rate of ceramic cup drilling, can be put into the water to play, that is, the drill bit and the cup in contact with the place immersed in water, so that the heat dissipation is faster, not easy to crack.

3, in the ceramic cup when punching holes, remember to bring gloves, so as not to accidentally cracked hurt hands.

Expanding knowledge

Ceramic cup punching simple method

1, the preparation of tools: a hammer, a number of sharp coarse cement nails, a number of wet towels.

2, put the ceramic cup in the water to soak, the water should be completely submerged ceramic cup, soak time of not less than 24 hours, soak for a period of time will be found on the surface of the cup to produce a layer of bubbles, this is the ceramic inside the water, will be extruded out of the formation of air, can be used to erase the hand bubbles, and continue to soak.

3, the ceramic cup out of the water, with a wet towel stuffed with internal, to plug tightly without leaving gaps, especially the bottom of the perforated part of the force must be towel bearing.

4, another piece of wet towel folded to the flat ground ready to punch, the ceramic cup stuffed with towels upside down on the ground on the towel, ready to punch.

5, with a sharp cement nail to the ready to punch the part of the force into the nail, hold the nail of the hand should be stable, to avoid nails in the bottom of the container sliding, nail the strength of the force should be big, as far as possible, stable and accurate. Pay attention to the frequency, careful operation, punch through the hole can be.

The above is what I shared today, I hope it can help you.