How to directly replace traditional fluorescent tubes with led t8 tubes?

I just changed a 40-watt fluorescent lamp in my own house. I bought an LEDT8 fluorescent tube 1 m2, with two inputs. 16 watts is basically equivalent to 60 watts of ordinary energy-saving fluorescent tubes. Very bright. You don't even need a flash to take pictures. But some brands don't need to dismantle ballasts. You should consult the seller. How many ballasts have been removed from the upconverter? This different brand is different.

Steps: 1 First disconnect the ballast with a screwdriver and a vise, preferably take it off. But my fluorescent lamp base is made in Zheng Tai, and the quality is so good that it has been used for 10 years. I couldn't get off the ballast at all. It was fixed in a complete thick iron base, so I disconnected the wire. After that, two wires must be disconnected from the ballast. Just connect this disconnected self. Some are directly twisted together and wrapped in vinyl cloth, and some are connected with that kind of connector by pressing the wires at both ends with screws. That makes no difference. Generally, it is not easy to screw together directly, so use this connector.

2 Disconnect the upconverter, then twist the disconnected wires at both ends together and wrap them with black tape (that is, insulating tape).

3 Close the base and restore to the original state. When installing fluorescent tubes, remember to put the end with Opal brand logo on the base of the current inlet. Put it in the right place and open it. All right.