How to adjust the drift and find the bottom of reservoir fishing

Question 1: How to adjust the drift and find the bottom fishing? Look at the picture to find the bottom.

Question 2: How to find the bottom tone of fishing? You can adjust it like this:

I think the water depth is about 2 meters. Just pull the drift seat to 1m or other distance from the hook, as long as it can be confirmed that it is from the bottom.

Add lead skin heavier than buoyancy, and then add. Throw it into the river, float and sink to the bottom, and then start peeling lead until two eyes are exposed.

Then you can get a group of bait that won't melt easily. Remember to add some wire drawing powder or flour, flour is better. Then hang two bait as big as soybeans to see if it will sink. It's supposed to sink to the bottom. If you don't sink to the bottom, increase the bait. After sinking to the bottom, start pulling the float on it until your eyes are exposed. It's almost over. (After the end, you can verify whether it is really the end. Hang three baits the size of soybeans to see if the float will be pulled down again, but it doesn't have to be the bottom of the mud. According to what you said above, I think your reservoir may be at the bottom of mud.

(You can't adjust the drift with the lead hook. Hang the usual size drift bait first. If it's really not heavy, you can hang it up a little. If you want to adjust the drift, you can watch the episode of Cheng Ning Adjusting the Drift, but just do as I say. And I don't think it is necessary to adjust the drift every time if I go to the wild, unless the fishing position and fish situation are very different from before.

Question 3: How to adjust the reservoir fishing drift? It means that the target fish is seen in the reservoir fishing. If it's carp fishing, adjust four fishing and six fishing. Catch crucian carp, then find the bottom first and then adjust the five fishing to three fishing. The reason is that the wind in the reservoir is strong and the number of eyes is higher than that in still water. ∞

Question 4: How to adjust the drift if the reservoir water is too deep? Deep fishing in reservoirs should be purposeful.

One: I guess your question is mainly about how to fish in deep water, not about drifting.

But no problem. Let me answer your question about water depth adjustment first. For water depth, the simplest method (without finding the bottom) is 1. Thread the line group (fishing line, float, lead cover seat, lead cover and hook) and increase the lead cover, and the whole float will be submerged. (Ok, the first step is completed) 2. Lift the whole line group, start cutting a part of lead skin, and then throw it into the water. If it is submerged, lift it up. When the eyes are adjusted, bait the hook. If it is submerged, pull the float to the tip of the pole for a certain distance, and then bait it until the float is out of the water for 2-3 meshes. OK is to catch 2-3 nets.

Two: How to fish deep in the reservoir? If it's too deep, find a shallow place. If it's not shallow, catch a sea pole. If you don't want to catch a pole, just catch half water (learn what half water means online) or silver carp. I wish you explosion-proof!

Question 5: How to adjust the air hook and half water to adjust the five eyes when fishing carp in the reservoir? After baiting the double hook, let it fall freely to the end. If the fish doesn't float out, lift the space beans up until the fish floats out of an eye or two acres of land. If the platform is exposed, lower the space beans until 1 to 2 meshes are exposed.

Steps/methods

Find the bottom, use lead skin or bait to hang on the hook to find the bottom, and adjust the buoy until it is flat.

Move the buoy after finding the bottom of the standard length.

Then add or subtract lead skin to make the buoy out of the water for 4 meshes (this is the mesh number of the basic adjustment method).

Hang the bait on the hook (the size of the bait is the size of each bait), and observe the number of eyes dropped by the buoy, which is the weight of the bait.

Then hang a double bait to push the buoy to the position where two destinations are exposed. Fishing adjustment 4. 2. This is the basic adjustment method.

The most important thing is that no matter how you adjust the standard, it is based on your own feelings. In this case, the downward movement of the buoy means fishing spirit, and the upward movement of the buoy means fishing dullness. But don't be bound by rules and regulations, just follow your feelings. I think my mouth is quite clear. In addition, buoys are calibrated every hour, because the draft of buoys and fishing lines will lead to the inaccuracy of buoys.

Matters needing attention

Except for the slippery old pit carp, other carp are not so particular. Generally, fishing goes up and down, such as 8 fishing, 4 fishing or 3 fishing. Except for special circumstances such as running water and making hooks.

Question 6: The fishing depth of small reservoirs is about 2-4 meters. Please explain in detail how to find the key point of bottom drift adjustment. "Vertical fishing zero" drift adjustment method. First, hang two hooks on the bait, float near the lead drop and throw it into the water, then gradually reduce the lead skin until the top of the float is flush with the water. Then, when the hook at the bottom lands, float the fish to the top, exposing one eye. You can go fishing.

Question 7: How to adjust the reservoir drift? 100 depends on what fish you catch, the small bait is small and the big bait is big. Drift adjustment is based on this. To catch crucian carp, you only need to adjust 34 meshes to catch 23 meshes, and then lift the pole at the next meal. Catch big fish, adjust 789 mesh, catch 34 mesh, and float the pole after dinner. It is particularly important to note that if the float exceeds the adjusted mesh and the pole is lifted, this is silver carp. In the process of drift adjustment, drop again without hook to find the bottom, so that the drift tail is horizontal or one eye, then pull the drift down to a distance of 10 cm for the length of the minor line, then peel the lead until it is adjusted to the required eye, then hang a big bait, and the drift will sink into the water and push it onto the fishing eye. This fishing eye is actually a personal habit of watching drift, as long as it is not bigger than the eye. If there is a signal from the float, but there is no fish in the lifting pole, push the float upward for 2 eyes at a time until the float moves and the lifting pole can catch fish.

Question 8: Taiwan Province Fishing and Drifting Skills How to drift in reservoir fishing? The simplest fishing reservoir depends on the target fish. If it's carp fishing, then adjust four fishing and six fishing. Catch crucian carp, then find the bottom first and then adjust the five fishing to three fishing. The reason is that the wind in the reservoir is strong and the number of eyes is higher than that in still water. ∞

Question 9: How to adjust the drift to find the bottom, pull it to 50 cm and throw it out, and then it must all be put into the water. Cut the lead skin and throw it once until it is adjusted to the mesh you want, then hang bait on the hook or hang a big lead skin and throw it out, and then it must be all in the water. Lift the pole up and down, and keep trying to push it to the net you want to catch.

Question 10: How to adjust drift and find bottom fishing? First put the hook in the water. If you can't see the drift, it means the water depth. You should adjust the drift and try again until it stands upright. If the drift is flat, it means that the water is shallow. Just adjust the drift and try to stand up straight.