Traditional Culture Encyclopedia - Traditional festivals - What is the calculation method of punching holes in general household curtains?
What is the calculation method of punching holes in general household curtains?
A, curtain perforation calculation method
1, double-fold drawing point, you can use equalizer to assist drawing point. If you don't need to divide the pattern, just split it equally.
2. Install the drill bit on a common hand drill and clamp the window with a clamp (note: double folding).
3. The edge of the hole is generally seven centimeters, and then it is drilled vertically by hand.
Second, the curtain opening method
1. Fold the curtains that need to be punched.
2. According to the calculation method of curtain punching, put the punching machine at the position where the curtain is to be punched, and put a cushion under the curtain (mainly for fear of damaging the floor).
3. Turn on the power supply and turn on the control switch, and gently press the handle to push it down!
4. When the bottom of the drill reaches the bottom plate, you can loosen the power supply open loop and remove the punch. Just install the upper retaining ring.
Three. Brief introduction of curtain punching machine
It is a small tool for punching holes, similar to a stapler. It is suitable for stamping all existing perforated curtains, not manual procedures.
Four, curtain perforation calculation
1, total width of single piece/number of folds = single fold width. Take a 6m curtain as an example: the total width of a single piece is 3m. After sewing, the total width of the single piece is 2.89 meters, divided by the set number of folds of 8. It is equal to the single folding width of 0.3 125. Enter 0.36 125 in the computer, press the ""key twice, and then press the "=" mark in turn until the eighth time is exactly 2.89 meters.
2. Press tightly with the machine and align the front and left and right sides of the curtain. This is the key to ensure uniform hole formation. Then visually inspect the distance between the left and right pressure plates to determine the opening position (the opening position can be centered around as required). Two sets of curtains should have the same perforation position.
3. Turn on the power supply, press the motor to punch, turn off the power supply after completion, and then finish punching. Open the curtains to see if the holes are accurate and even.
The calculation method of curtain perforation ends here. In fact, there are many ways. Look at the windows differently and operate the curtains differently. Don't follow a routine to avoid making mistakes.
Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp; Wb, you can get it for free ~
- Related articles
- Why do people like the media? What is the trend of the media?
- What procedures are needed to get engaged in Yunnan?
- The characteristic of ancient Greek culture is about 500 words.
- What are the common problems in foreign trade marketing?
- What should the diet pay attention to after appendicitis operation?
- What problems do you think are caused by teaching to the test?
- Male weighs 55 kg, what is the level of hands 100 kg?
- Dad, can shoes be used as sports shoes?
- What does the tradition of shadow play mean?
- What is the working principle of diesel fuel system?