Seeking to make a painted eyebrow cover

The eyebrow harness is made from ponytails. After you get a ponytail (preferably black), pick a thicker, longer ponytail and use it to tie the clasp, and save the rest for braiding the beam.

The length of the eyebrow set is not limited, there are 20 buttons, 30 buttons, and 40 buttons, depending on the situation. It is best to have a little bit of each length, so that the set can be placed according to the location.

The set of buttons is made of three ponytails. The root end to play an ear, the tip to play a lump, and the tip through the root end of the ear, the formation of the "6" shape of the live set of buttons. The diameter of the buckle is about six centimeters. In order to have the same size, the size can be measured one by one and then braided. The beam is braided with horsetail or brown silk. There is an ear at the beginning. Whenever the length is four or five centimeters, a set of clasps is placed. You can make it as long as you like. After braiding, tie a section of thread at the end, which is usually used to bind the set, and used to bind the set of poles when the eyebrow is set. All done, the set of buckle all open and closed in a piece, forming a "○" volume, in order to carry with you.

Capture eyebrow eyebrow net, is woven with fine nylon thread or car clothing line. General net height of 2-3 meters, about ten meters long, mesh diameter of three centimeters, commonly known as the "two fingers eye". Its playing method and weaving fishing with the "river net", is the same. That is, with two fingers thick and thin netting board needle by needle.

After the net is hit, it is around and in the middle of each into a thicker and solid line will be fixed up. Around the "outline rope", the center of the "net root and stem". The two ends of the net on two about 2.5 meters to 3 meters of bamboo poles, and the two ends of the "program rope" tied to the bamboo poles into.

There are two kinds of raw materials for the production of sticking glue of the painted eyebrow tree: one is the "rice tree" of the skin; the other is the "mouse thorns" of the skin of the tree. These two trees are common small shrubs in the mountains.

The specific production method is: will be above a kind of bark to find, with a pestle or other tools to pound the bark into a ball, to the river or stream side of the ditch, in the water while scrubbing the hand while pulling, so that the water will be the bitter skin and wood debris washed away, leaving a very strong viscous milky white gum.

It must be noted that this glue, soaked in water, it is not sticky at all, after leaving the water, the less water it is more sticky. Therefore, usually put it in a bottle filled with water spare. In addition, with the viscose sticky eyebrow, but also must be based on the amount of viscose, ready to cut a few more slippery stick, on the mountain viscose bird, the few small stick with the use of.

The raw material for making sticky eyebrow oil glue is tung oil. Specific production methods are: tung oil poured into the pot, first with the fire and then with a strong fire to simmer and fry, to the surface of the oil appeared foam and gradually disappeared and smoke, immediately immersed the pot into cold water, while using a bamboo slice in a direction of the rapid churning, so that it cooled.

It should be noted that this oil viscose is easy to dry, made of water must be put into the bottle immediately after preservation, with the use of water and then take it out, do not use it again to save it. In addition, it is also necessary to prepare a few oil glue stick, in order to use when going up the mountain.

To the mountains after the discovery of the paintbrush, cut a not too large bamboo or tree as a set of rods, set the tip of the rod to leave a fork. Root with a knife aligned with the tip of the fork, the set of poles split into two broken in half, another small sun fork, the set of support up. Sleeve pole should be a little longer than the set, in order to cut a fork at both ends of the fork in the appropriate branch or stick inserted. At this point, it is necessary to see which direction to chase the eyebrow, and the eyebrow walk high and low, find a suitable place to hold up the eyebrow set installed. After the set is set up, it will chase the eyebrows to fall into the set.

The eyebrow should be taken immediately after the fall of the set. Because the eyebrow set is the neck, not in time to take, over time, the eyebrow will be strangled to death. Take the eyebrow, hands and feet should be light, movement should be fast, at the same time to hold the eyebrow steady, otherwise, either the eyebrow to fly, or the eyebrow hurt and disabled. This is what the birders must pay attention to. If you find that there are other paintbrush, and it will be chased to fall set.

After discovering which mountain has the eyebrow, in a suitable place near it, the net is opened up, pulled in the middle of a forest with no trees in the way, and put the net body high up. After the net is pulled up, it is chased by hand to touch the net. Generally speaking, after touching the net, the eyebrow will naturally fall into the net pocket. This is a good time to pick it up. If the light touches the net without falling into the net pocket to take, it is possible that the eyebrow struggles to slip off. Because it is not yet firmly set. After the fall of the eyebrow out of the net, if you still find that there is no fall of the eyebrow, take the same approach, will be the other eyebrow to chase the fall of the net.

To the mountains after the discovery of the eyebrows, the sticky glue out of the water, pull out a little sticky glue head, along the way wrapped in the sticky glue stick with me. After the moisture dries, it gets stickier and stickier. At this point, choose a good spot, the sticky glue stick fixed, the painting eyebrow chase over. As long as its feet pale wai glue stick, can not pull up the feet, a wing beat, it will be stuck. At this point, the bird will be taken out, and water will be in its feet and feathers on the sticky glue wash can be. It is important to note that when not in use, the adhesive is again removed with water, pinched into a ball and kept in a bottle with water for safekeeping. Hope this helps